canneed “ABT-100噴霧罐耐壓檢測儀”適用于檢測噴霧罐罐底耐壓強度（凸罐強度）和爆破強度。將噴霧罐放入保護槽里充水加壓來檢測耐壓強度。測量壓力大約在2.2到2.8 Mpa。儀器操作使用簡單。待檢測罐須裝滿水，罐體可自動吸附在夾頭上，夾緊后，緩慢加壓，當壓力超過罐的耐壓極限時，罐底及罐蓋部位發生變形向外凸出，由于體積突然增大，罐內壓力突然減少，此時壓力表指針會有短暫而且明顯的停滯，顯示值是噴霧罐耐壓強度值（凸罐強度）。在此同時壓力繼續緩慢上升，罐破裂，壓力表指針迅速回零，記憶指針顯示的是噴霧罐爆破的最大值。一次裝夾便可完成兩個過程及讀數。技術參數: 氣源壓力：0.5Mpa測試壓力：0-4Mpa分度：0.2Mpa 尺寸：長x 寬x 高:555 x 400 x860 mm 重量：50kgThe “canneed ABT-100 Burst Buckling Tester for Aerosol Cans ” is used to determine the buckle value of bottom and end (dome) of aerosol cans and the pressure at which the can bursts. At high pressures from approximately 22 - 28 bar, it may happen that deformations of the valve and a higher burst pressure. Technical data (changes reserved):Pneumatic supply: 5bar Max. Working pressure: 40 bar Max. diameter: all standard aerosol cansDimensions: 555 x 400 x 860 mm(W x D x H)Weight: 50 kg